Construction Automatic 5-12mm Reinforcing Mesh Welding Machine

For better performance of the machine, the following requirements should be noted during the plant site selection and equipment layout:

Surrounding ambient temperature: 5~40 ℃

Relative air humidity: 90% maximum of 20 ℃ and 40 ℃ maximum of 50%;

Elevation shall be less than 2,000 m;

Keep away from large vibrating equipment;

Dust, acid, corrosive gases or substances in the surrounding air shall not exceed the normal content;

Can not be used in the open air, must be used in the factory factory guarding the gate of the factory;

Places away from a strong magnetic field.

Power: AC 380V 50HZ recommends an independent 400KVA transformer with 120 square mm copper wire from the equipment ≤ 50m cable.

Water: provide clean and neutral circulating cooling water, inlet temperature not more than 40 ℃ in summer (reference cooling pool volume not less than 2 cubic meters), pressure 0.2-0.3MPa

Gas: Provide screw air compressor with pressure 0.6-0.8MPa and ≥ 2m3/min.

This device is the core part of Construction Automatic 5-12mm Reinforcing Mesh Welding Machine. It is mainly to weld the meshes at a high speed by cooperating closely with others device.

The welding electrodes head of Construction Automatic 5-12mm Reinforcing Mesh Welding Machine use high-quality materials, which make them more wearable and with better conductive, and also have a long life, reduce production costs.

The improvement of design of welding transformers of Construction Automatic 5-12mm Reinforcing Mesh Welding Machine meets the demand to weld continuously wires of 12+12mm at a high speed at the moment when saving energy.

Construction Automatic 5-12mm Reinforcing Mesh Welding Machine electrodes adopt circulating water cooling, which extends their service lives, and ensures the long-term operation of the equipment.