300KN Hydraulic Bus Bar Cutter with 200mm Cutting Capacity and Hardened Steel Blade

The CWC-200 is a hydraulic bus bar cutter used to cut copper and aluminum busbar cleanly during substation installation, panel fabrication and electrical maintenance. It applies a 300KN cutting force through a hardened steel blade, producing a low-deformation cut on busbar up to 200mm wide without the material distortion and burrs left by sawing or shearing. The non-conductive fiberglass handles and a pressure relief valve keep the operator protected during high-force cutting.

• 300KN Cutting Force: cuts copper and aluminum busbar up to 200mm wide in a single stroke.
• Hardened Steel Blade: maintains a clean edge with minimal deformation of the busbar section.
• Non-Conductive Handles: fiberglass handles insulate the operator during high-force work.
• Safety Relief Valve: automatic pressure relief protects the tool from overload.
• Forged Cutting Jaws: reinforced frame holds blade alignment through repeated use.

• Substation busbar installation and cutting to length
• Power distribution panel fabrication
• Electrical room busbar modification
• Emergency repair and replacement work

• Produced under an ISO 9001 certified quality management system
• Work methods aligned with OSHA equipment and IEC practice
• Factory function and pressure testing before packing

• OEM and custom configurations available
• Technical guidance on tool selection for busbar size
• Spare blade and after-sales support

• Minimum order quantity: 1 piece
• Price: negotiable depending on configuration and quantity
• Packaging: plywood case for export

To confirm a specification, request a quotation or discuss a custom configuration, contact our engineering sales team with your busbar material, width and thickness.