Mechanical Electrical Single Punch Tablet Pill Press Machine

Tablet Press Parameter

Tablet Press Description 

Small desktop electric continuous tablet press machine, can also be hand-cranked. The plane comes with a die, which can be changed to press tablets of different shapes and sizes. The filling depth of the material and the thickness of the tablet can be adjusted.

TDP Single Punch Tablet Press,which can press the powder material into tablet,can be widely used in pharmaceutical factory,chemical factory,hospital and R&D bureau.

This machine is with good performance,strong suitability,simple operation,easily repair,small cubage light.Even under the conditions or power cut,hand swing it available.Compare to original TDP model press machine,it is enlarged the machine intensive and engine power with bigger strength.In the meantime enlarge the filling depth,hence to expand the specification range of tablet.Therefore,this machine can meet the demand of difference kinds of Chinese traditional medicine and Western medicine and other similar product’s requirements.It’s deeply welcome by our customers in difference field.

Installation and Connection of the Press Machine

Tablet Press Machine should be installed on the wood workable(as well on the cement table).Use 4units of M12 bolts for fix it.The heights from the workable surface to ground is around 600mm(consider easily to the operation).To be convenient to disassembled and repair,there should be a hole the diameter around 35mm counter to the bottom of pressure rod.

To insure the safety connecting ground wire before connecting the power,and then remove the triangle belt,to connect the power of the machine and switch it on to observe the roiling direction of the operation.(The rotary direction should be opposed to the arrow direction on the shield or hand wheel).If the rotary direction were incorrect,it would connect the line additionally,and the install the triangle belt.