Reasonable Design Of Water Vapor Dual-purpose Drilling Rig With Strong Drilling Speed

The Pneumatic 200 Drilling Machine is powered by compressed air, with a compact structure and easy operation, suitable for mining, tunnel, slope and other engineering projects. It can efficiently drill into rocks and concrete, and is commonly used for blasting and anchor hole construction. It has strong power, safety and reliability, and is suitable for outdoor and non electric, explosion-proof conditions.

After each assignment, clean up the dust and rock debris on the machine body, and check whether the air pipes and joints are leaking or damaged.

Regularly add lubricating oil to ensure smooth lubrication of the impact mechanism and reduce component wear.

Check the wear of drill rods and bits, replace them promptly if they are severely worn, and avoid affecting drilling efficiency.

Regularly dismantle and inspect vulnerable parts such as intake valves and pistons, clean impurities, and replace aging seals.

When parked for a long time, drain the accumulated water inside, perform rust prevention treatment, and store in a dry and ventilated place.

Preparation: Connect the air compressor air pipe, check the integrity of the drilling rig, drill rod, and drill bit, and clean the working surface.

Positioning: Align the drilling rig with the hole position and stabilize the machine body.

Drilling: Open the air valve, press lightly to advance, and start drilling at low speed to prevent deviation.

Drilling: Apply uniform pressure, use compressed air to discharge slag, and maintain the stability of the drilling rig.

End: After reaching depth, slowly lift the drill, turn off the gas source, and clean the equipment.

Conclusion: Organize the pipeline, inspect and maintain the drilling rig, and store it properly.