Geological Exploration Drilling Rig Parts Drilling / Rig Accessories Size Customized

Drilling Rig Components Brief Introduction

The rotary assembly of the drilling rig assembly is the same as that of the original drilling rig. It can be used arbitrarily, and the torque is strong. The hole can be tilted 20 degrees

Drilling Rig Components include Vertical box / gyrator / head

The vertical shaft of the rotator is desalinated, which is more wear-resistant. The main rod is hexagonal, and the main rod is 46 × 51mm, which is easy to deal with the gravel layer and the gravel layer
Pebble layer and other complex strata.

Drilling Rig Components Specifications

Drilling Rig Components Purpose

It be used for All of drilling rigs: XY-1, XY-1A, XY-1B, GK-180, GK-200, DPP-100 and other series of drilling rigs

What should be paid attention to during the operation of the drilling rig?

a. When engaging the clutch or rotating the working wheel, it must be light, uniform and stable;

b. When changing the speed, engaging the horizontal and vertical axle boxes and changing each transfer handle, the clutch must be placed in the disengaged position or the working wheel must be stopped;

c. When using the lift, it is forbidden to press down the left and right handlebars at the same time;

d. After the gear oil pump starts, pay attention to the reaction of the oil pressure gauge and the hole bottom pressure indicator. In the process of drilling, when the pressure at the bottom of the hole needs to be increased or decreased, it should be adjusted gradually, and sudden increase or decrease is not allowed; When using the oil pressure system to quickly lift the vertical shaft (fast reversing rod), it is only allowed to carry out under the original load to prevent damage to the parts;

e. Before moving the XY drill, loosen the locking mechanism, wipe the guide rail clean and apply lubricating oil; It must be locked after moving;

f. Pay attention to the impact sound of all parts of the machine at any time; Whether the gearbox, bearing, shaft sleeve, horizontal and vertical shaft gearbox, etc. exceed the hot hand temperature (60 ℃), if so, it should be eliminated; g. All oil pressure control handles shall not be used at the same time;