Introduction

The cross-arm 13 holes is an angled bar section used for roll-out overhead parallel lines. Equipped with 13 holes this pole bracket mounts on a bracket compatible with the pole to be equipped.  Its role is to enable fastening points for deadending and suspension applications.  

Thanks to its 820mm length, this pole hardware preserves cable against environmental constraints by offsetting them from the poles.  

Crossarm 13 holes can receive multiple drop cross-arm brackets at it extremity, enabling thus to anchor drops perpendicularly to the main network.

Application

Cross-arm with 13 holes can be used for pole, extension bracket, polt mounting on fiber optic and copper networks

Up to 8 routing cables

Cross-arm 1 holes can be used us strut to creat an offset with a cross-arm with 13 holes

Cross-Arm 11 holes Characteristics

Material: hot dip galvanized steel

Hole spacing: 60mm

Dimensions: 820x40x40mm

Installation:

on non drillable poles (concrete, composite,...)

on drillable poles (wooden)

on pre-drilled poles (steel, concrete,...)

on extension brackets (REFO,...)

Our service

1, Product consulting service
2, Cost-saving advice
3, Fast response speed to needs
4, Professional and complete reference documents
5, Safe and cheap transportation solutions
6, 7*24 Hours After Sales Service

Contact us

Email: sales@getotelecom.com

Whatsapp/Tel: 86-18600124328

Web: www.getotelecom.com

Company

Introduction

The cross-arm 13 holes is an angled bar section used for roll-out overhead parallel lines. Equipped with 13 holes this pole bracket mounts on a bracket compatible with the pole to be equipped.  Its role is to enable fastening points for deadending and suspension applications.  

Thanks to its 820mm length, this pole hardware preserves cable against environmental constraints by offsetting them from the poles.  

Crossarm 13 holes can receive multiple drop cross-arm brackets at it extremity, enabling thus to anchor drops perpendicularly to the main network.