I.the installation instructions

In order to save your precious time, this manual does not introduce common sense of common

use of electrical appliances, please follow the common sense of common electrical appliances.

Before using the device, please read the operating instructions carefully so that you can quickly

become familiar with the commissioning and use of the device.

II. the installation steps

1. Connect the HDMI output of the splicing processor to the HDMI input port of the liquid crystal

display unit, and each display unit can be connected to any HDMI output port of the splicing processor;

2. Connect the signal source to be displayed to any one of the HDMI1, HDMI2, and DP interfaces;

3. The first time you set up the video wall controller, you need to connect to the RS232 interface

of the video wall controller through the serial cable.

The installation diagram is as follows:

power on

After the above cables are connected, plug in the 100-240V AC power supply, turn on the power switch of the device,

the power indicator light is red, and the device is in working state;

SOFTWARE COMMUNICATION SETTINGS

The first use of the 4K video wall controller needs to be debugged by software according to the actual arrangement

of the LCD screen. Before the debugging, the control software and the device need to communicate normally.

The following is the communication setting mode:

Open the Software folder inside the CD and copy it to the computer hard disk, open the VideoWallcontrol.exe file inside,

and then pop up the following interface;