THJ - 63 20-63mm Portable Ppr Pipe Socket Fusion Welding Machine Tool
 
Socket Fusion Welder Presentation:

 
Product Type: PPR Welding machine 63mm
Item: THJ-63A
Heating Mold: Electric temperature controller
Supply Type: “Aquafusion” Brand or OEM
Color: Green, Red, Blue and customized
Guarantee: 3 years Warranty and Spare parts factory cost
MOQ: As Agreement

 
Socket Fusion Welder Technical Data:
 

 
Fusion Instruction:
 
1,Fix up a proper heating sockets. Tighten it with an inside turret according to the type of pipes needed, In general, the smaller sockets in the front while the bigger back.
 
2,Switch on the electricity to make sure the red light is on, Showing that the welding machine
goes into the state of auto-control of temperature and then operate it.
 
3, Cut off your pipe and put it with its fittings into the welding sockets, operate as the table below shows. When the heating time is up, take down from the sockets both the pipe and its fittings and straightly insert to the depth needed so that a flange can be seen as the joint.

 
Service Advantage:
 
1, All machine according international standard.
2, Welding sockets size match Europ Metric or US inch standard or customized.
3, The factory will change any parts of the fusion tools for free charge which the tool is proved to be quality problem not misuse problem within 36 months since from the day leaving factory.
 
Workshop Display:
 

 
Application:
 

 
How to use:
 
1. Apply die head
Place the welding machine on the stander, chose die head according to pipe’s diameter, and fix it on the machine. In regular, the small end is at the front, the bigger end at the back.
 
2. Power on
Power on (make sure the power should be with leakage current protector) , the green light and the red light on, wait till the red light off and keep greenlight on, which indicates the machine enter into auto temperature control mode and the machine can be used.
Note: during the auto temperature control mode, the red and the green light will be on and off alternatively, this indicates that the machine is under control and it will not affect operating.
 
3. Fusion pipes
Using cutter to cut pipe vertically, push the pipe and fitting into die head without any rotation. Take them off immediately when heating time reached (see the table below) and insert