Reinforcing Mesh Welding Machine Description

1. Wire diameter: 3 - 8 mm

2. Line wire from: pre-straightening and pre-cutting wire

Cross wire from: pre-straightening and pre-cutting wire

3. Control system :synchronous with PLC control ,touch screen board

4. Cross feeding system :automatic falling controlled by air pump, then the cross wires falling automatically one by one.

5. Advantage: steadier welding, less noise, higher speed.

Reinforcing Mesh Welding Machine Technology

1. Welding System: the machine adopts synchronous and PLC control technique. The welding power comes from the spring. At the same time, the below welding electrodes are equipped with water cooling welding system to make sure the welding quality and prolong the life.

2. Mesh pulling system: the machine use servo motor to pull the mesh, in this case the mesh size is adjustable and accurate.
3. Mesh falling system: automatic falling mesh panel system is adopted, so it save much labor to move the mesh panels.
4. Control system: control cabinet adopt touch screen operate system, you canchange welding time and mesh opening size through touch screen.

Reinforcing Mesh Welding Machine Parameter

Products & Application

1.  Suitable materials: Stainless steel wire, low-carbon steel wire, galvanized wire, iron wire, rebar

2. The mesh panel application: Mesh for building huge factory, bridge, road, highway, subway and so on.

Weft wire storage bin: This storage bin can store about 1Ton weft wire.It will continuous feed for the automatic hopper below during welding

Welding electrodes

Warp Wire Sending Device: The warp wire feeding device uses the cylinder to clamp the warp wire, and uses the servo motor to send the warp wire to the welding position.