03931063-315 C.A.T Fuel Pump Seal 03931063-315T FKM PTFE HLPS Oil Seal

03931063-315 C.A.T Fuel Pump Seal 03931063-315T FKM PTFE HLPS Oil Seal

Measures For Oil Leakage Due To Inadequate Oil Seal:
1. Master and recognize the basic knowledge of fake and inferior products, and purchase high-quality and standard oil seals.
2. During installation, if the roughness of the outer surface of the shaft diameter is low or there are defects such as rust, burrs, etc., smooth it with a fine emery cloth or whetstone; apply clean engine oil or grease to the lip of the oil seal or the corresponding position of the shaft diameter. Apply sealant to the outer ring of the oil seal, wrap the key way on the shaft with hard paper to avoid scratching the lip of the oil seal, and use a special tool to rotate and press the oil seal inwards. Do not smash the hard seal to prevent deformation of the oil seal or squeeze the spring and fail; If there is lip cuffing, the spring falls off and the oil seal is skewed, It must be removed and reinstalled. It should be noted that when the shaft diameter is not worn and the spring force of the oil seal spring is sufficient, do not tighten the inner spring without authorization.
3. The oil seals applied to machinery generally have to be inspected, maintained and maintained when the general working conditions are poor, the ambient temperature difference is large, the dust is excessive, and the vibration of the machine tool frequently changes the stress condition of the machine parts.
4. If the shaft diameter and bearing are seriously worn; The rubber seal oil is aging or the spring is invalid, etc., repair and replace the corresponding parts in time.

About Oil Seal Use Guides:

• Oil seals that are not used temporarily should be kept properly to prevent contamination with oil, dust or sun exposure.
• When the shaft diameter is worn into a "V"-shaped groove, so that the contact pressure between the new oil seal lip and the shaft cannot be reduced, the displacement method can be used to make up.
• When the lubriC.A.Ting oil volume of the reducer is less than or equal to 7 liters, the amount of lubricant added per liter is 20-30ml;
• When 7-15 liters, the amount added is 15-20ml per liter of lubriC.A.Ting oil;
• When>15 liters, add 10ml per liter of lubriC.A.Ting oil.

Product Show:

Thanks for viewing our listings. Please click "ask a question", or call us if you have a parts need that you do not see listed here. We will do our best to loC.A.Te the parts you need, and make every effort to save you money.