707-98-11450 7079811450 Komatsu Blade Cylinder Repair Seal Kit For PC22MR-3 PC20MR-3

707-98-11450 7079811450 Komatsu Blade Cylinder Repair Seal Kit For PC22MR-3 PC20MR-3 

Product Introduction:

Related Parts:

Our Services:

1.We will respond to your inquiry as quick as we can.

2.We can negotiation the price until make our corroperation pleasure.

3.In terms of product problem,we are willling to answer your any questions.

4.We can design mold opening according to customer needs.

5.We mainly produce seals& rubber products.

6.100% quality control, 100% full inspection before packaging to ensure zero defect.

7.We can provide you with OEM services with your own trademark.

8.We attach importance to your using experience,so our after-sale service is considerate.

9.Looking forward to your inquiry.

Product Show:

Countermeasures for oil leakage due to poor sealing of oil seal:

1. Master and identify the basic knowledge of fake and inferior products, and choose high-quality and standard oil seals.

2. During installation, if the outer surface roughness of the shaft diameter is low or there are defects such as rust spots, rust, burrs, etc., use a fine emery cloth or oil stone to smooth it; apply clean oil or grease on the oil seal lip or the corresponding position of the shaft diameter. Apply sealant to the outer ring of the oil seal, wrap the keyway on the shaft with hard paper to avoid scratching the lip of the oil seal, and use a special tool to rotate the oil seal inward and press it in. Do not smash hard to prevent the oil seal from being deformed. Or crush the spring and fail; if the lip is flanged, the spring falls off and the oil seal is skewed, it must be removed and re-installed. It should be noted that when the shaft diameter is not worn and the oil seal spring has sufficient elasticity, do not tighten the inner spring [4] without authorization.

3. Oil seals used in machinery are generally subject to harsh working conditions, large environmental temperature differences, a lot of dust, and frequent vibrations of machines and tools, when the stress conditions of the parts are constantly changing, they should be inspected, maintained and maintained frequently.