Flexo Cardboard Printing Slotting Die Cutting Machine With Automatic Zero Reset Device

 Automatic zero reset device

1), the paper feeding department, printing department, slotting department computer automatically reset to zero.

2) Generally, the carton uses an automatic zero reset device, and it can be adjusted to the correct position with a few trial prints, reducing the waste of cardboard.

2. Printing Department

1. Printing roller (plate roller with plate Ø410mm)

1), high-quality steel plate material, surface grinding, hard chrome plating.

2), balance correction, stable operation.

2. Embossing roller

1) The surface of the steel pipe is ground and plated with hard chromium.

2), balance correction, stable operation.

3) The roller dial between the impression roller and the printing roller shows manual adjustment, the adjustment range is 1-12mm, and the cross slide mechanism is adopted, and the transmission gear always guarantees the correct meshing state during adjustment.

3. Anilox roller

1), hard chrome plating, static and dynamic balance treatment, deep hole boring processing, stable high-speed operation.

2) The dots are consistent and the ink is evenly applied.

3) Extend the service life of printing plates and rubber rollers.

4) Pneumatic lifting and lowering of the anilox roller can prevent the ink from drying out in the anilox roller cavity when the printing plate is repeatedly inked and when the machine stops for a short time.

5) Manually adjust the gap between the anilox roller and the printing roller. The adjustment range is 1-8mm. It is connected by a cross slider. The transmission gear always guarantees the correct center-to-center toothing during adjustment.