Easy Operate 380V Double Facer Machine Of 3 Ply Corrugated Cardboard Working Line

Easy To Operate Double Facer Machine Of 3 Ply Corrugated Cardboard Working Line

Easy To Operate Double Facer Machine Of 3 Ply Corrugated Cardboard Working Line

Before starting up, carefully check whether all electrical appliances and steam are normal, and fill all lubricating parts and chain sprockets with specified lubricating oil, then turn on the steam of all preheaters, put glue in the corresponding rubber trays according to the number of layers of produced paper, install the required facial paper on the shaftless bracket, and ask the hanging surface layer to face down. After starting up, observe whether the sizing amount is appropriate, and if not, adjust it. Adjust the gap between the floating roller and the applicator roller to 0.2 mm smaller than the thickness of the single-sided cardboard to be passed. And the gaps at both ends should be even and equal. After being delivered from the triple preheater, the single-sided cardboard and facial paper pass through the preheating roller and applicator roller, align the single-sided cardboard and facial paper, and send them to the hot plate together. At the same time, observe whether the amount of glue is normal, and check whether the corrugated peak is evenly sized. After production, lift the ballast roller, turn off the glue, release the glue in the glue pan, clean the applicator roller, clean the glue pan, turn off the heat source, open the bypass to discharge the residual steam and condensate in the machine, lift the conveyor belt and remove the sundries on it, and keep the equipment and site clean. plural marker for pronouns and a few animate nouns
The requirements for duplex positions are as follows. No, Jiang
1. Fully grasp the working principle of cardboard line and work in strict accordance with operating procedures.
2. When feeding and starting, all layers of paper must be aligned, and the face paper and single-sided corrugated board are not aligned, with a maximum of 5mm. Check the adhesion of corrugated board at any time after the equipment runs normally.
3. Be sure to check the quality parameters of glue before production.
4. According to the operation of paper, steam pressure and single-sided machine, flexibly grasp the running speed of the whole line.