Factory Sale JYQD-V8.8B 110V 220V AC BLDC Motor Controller for Household Appliance.

Factory Sale JYQD-V8.8B 110V 220V AC BLDC Motor Controller for Household Appliance

Model No. JYQD-V8.8B

BLDC Motor Driver Major Parameters

Power Input:90-265VAC

Rated power:130W

Suitability :Sensorlesss motor

Max power:250W

Max curernt: 1A

---------------------------------------------------------------------------

Protection: Over-current, short circuit, over voltage, under voltage, locked rotor, over-heating

Control algorithms: Square wave

Dimensions:77mmx62mmx33mm

Speed Control:PWM/0-5V

Speed feedback signal output:Yes

Working temp:-20℃—85℃

Application Guidelines

1. Confirm that the voltage and power parameters of the motor not exceed the range as specified.

2. JYQD-V8.8B is driver board without housing and heatsink, it can drive the motor below 100 watt without any heatsink, but needs normal ventilation.

3. The 5V output port on the drive board is forbidden to connect external power equipment. It is only applicable to external potentiometer or switch for speed adjustment, commutation and enabling operation

BLDC Motor Driver’s Application

Electric skateboard

Electric scooter

Electric wheelchair

Hoverboard

Electric unicycle

Electric Moped

Electric go kart

RC car

Industrial robot

Logistics conveyor belt

Automation equipment

CNC machines

Self-propelled lawn mowers

BLDC Motor Driver’s Wiring

1. Control port

5V —Driver board internal output voltage, external potentiometer or switch for speed adjustment and reversing

operation

Z/F —Rotating direction control ports. Connect “5V” high level or no connect is Forward direction, connect 0 V low level or

connect to GND is reverse direction.

VR —Speed control port. Analog voltage linear speed regulation 0.1v -5V, The input resistance is 20K Ohm ,connect with GND when input PWM speed regulation, PWM frequency:1K-20KHZ; Duty cycle 0-100%,PWM amplitude:5V

M— Speed pulse signal output,5V pulse signal

GND—Used for Driver board internal control

2. Power port

MA ----motor phase A

MB ---- motor phase B

MC---- motor phase C

GND ----DC-

VCC----DC +

4. Use shielded wires if the drivers board has more than 50 cm distance from the motor, otherwise it may lead to abnormal driving, affecting the normal use

5. Control port distance: 2.54mm,Power port distance:3.96 mm

6. Pay attention to the insulation between the driver MOSFET and the heatsink or the installation plate.

BLDC Motor Driver’s Dimensional Drawing