Product name:

Antenna Moisture Protection Sleeve For Antenna To 1/2 Coax Connection

Description:

Cold shrink sleeve covers low-voltage cable, wire connections, joints, and terminals, and it shrinks when the core is removed to create tightly sealed bundles. It doesn't require heat guns, so it can be used where gas and electrical heating devices are not allowed. It is used across a wide variety of applications to provide electrical and mechanical protection against environmental damage.

Features:

• Simple and quick installation, without tools.
  
• Custom sizes from 12 mm – 70 mm. Covers many different cable sizes.
  
• Tighten the seal, even after many years, and keep the elasticity.
  
• No mastic, tape or mold mass is needed.
  
• No need for heating.
  
• High resistance to fungi, acid, alkalis, ozone and UV radiation.
  
• Easy to uninstall again.

Applications
Primary electrical insulation for all solid dielectric (rubber and plastic) insulated wire and cable splices rated to 1000volts

Picture for your reference

Introduction:

 EPDM Cold Shrink Tubes are a series of open-ended, tubular rubber sleeves, which are factory expanded and assembled onto a removable core. They are supplied for field installation in this pre stretched condition. The core is removed after the tube has been positioned for installation over an in-line connection terminal link allowing the tube to shrink and form a waterproof seal. The insulating tube is made of EPDM rubber which contains no chlorides or sulphurs.