200m/Roll Wood Veneer Edge Banding Fancy Plywood 8% Moisture

Width 30MM Quality Veneer Edge Banding, White Oak, Prompt Delivery

• Wood Species: White Ash

• Botanical Name: Quercus alba

• Technics: Finger Jointed

• Grade: A

• Length:200 Meters / Roll

• Width: 30MM

• Thickness: 0.6MM

• Back: Fleece Paper

• Moisture Content: 8-12%

• Usage: Furniture, Fancy Plywood/MDF; Flooring,Door, Cabinet, Chest

TECHNIES SHEET:

ABOUT VENEER EDGE BANDING:

Tips for edgebanding plywood

It doesn’t matter what kind of veneer edging you’re using, there are a few tricks that will help you with your edgebanding.

Prepare your edge

Clean your edge thoroughly. Nothing screams “amateur” like particles of wood trapped under the veneer edge. I usually use a fine piece of sandpaper to polish the edge. Then I run my hand to detect if there are any imperfections left.

Size of your edge

Before applying your veneer, make sure it’s a bit longer and wider than your edge. You can cut it to length, but always leave an inch or two than they need to be. I will trim the unneeded ends later on.

Rolling the veneer

A good trick is to use a rubber roll on your edge, right after you glue your veneer on. When pushed, it rounds itself, smoothing out irregularities in the veneer. Do not push too hard either, so you don’t press out the glue from under the veneer.

Trimming the ends

Always trim the ends first.

Put the edge downwards so that the veneer is pressing against the table.

Using a utility knife that has been sharpened, cut off the excess veneer edge. Run your blade against the edge of the plywood for a clean slice, perfectly in line with the corner.

ABOUT US:

Lonson Veneer Co.,Ltd was established in the year 2012, with more than 9 years in the wood veneers producing, exporting, our wood veneer already widely acceptable by the clients from more than 20 countries, like South Korea, UAE, India, Pakistan, Vietnam, Indonesia, Malaysia, Bangladesh, etc.

Our wood veneers species cover widely, species like white oak, red oak, white ash, American black walnut, cherry, maple, hickory, Burmese teak, ebony, pine, birch, basswood, apple wood, eucalyptus......are all available. Sizes also varies from wood flooring size to furniture size, door size, panel size. Different grades could be obtained accordingly.

WHY US:

1, Experienced wood veneers manufacturer and exporter for 9+ years.

2, Various kinds wood veneers, including Natural wood veneer, Dying veneer, Fumed veneer, Rough Cut veneer, Recomposed veneer, etc.

3, Different sizes and grades are all available. Wood Flooring veneer, Furniture size, door size, panel size, thickness from 0.4-2mm.

4, Professional and Considerate Service.

5, Fast Delivery and Continuous Supply.

FACTORY SHOW: