Mini 12v Dc Diaphragm Water Pump For Waterpik Automatic Teapot Tooth Cleaner

Price Negotiable

Price: Negotiable

MOQ: 2000

Delivery Time: 25-45 days

Brand: Zhaoli

Product Description

DC Water Mini Pump Air Pump For Waterpik Automatic Teapot Tooth Cleaner

Specification:

Test Environment	Ambient temperature of 20℃ and relative humidity of 65%RH.
Position	Horizontal
Load	Air pressure 300mmHg
Operating condition	5℃~45℃, RH 30%~85%
Storage condition	-20℃~60℃, RH 30%~85%

Rated voltage	12.0VDC
Operating voltage	9.6 - 14.4 VDC
Air flow(free load)	At DC12.0V, the air flow is ≥0.8L/min with no load.
Water flow(free load)	At DC12V, the water flow is ≥ 1200mL/min with no load.
Rated current	The highest current is less than 400mA while the pump for drawing water.
Restart voltage	Operating voltage range gas filled pressure untills -30KPa(30 KPa) pineland then add DC9.6V voltage pump should restart.
Noise	The sponge of 5 cm underlying is 30 cm away from the noise meter. The dB value measured by DC 12V power supply pumping is less than 55 dB.
Terminal tension	Hanging a 0.5 Kg static load on the terminal of the pump will not cause a damage on the pump.

Low-temperature characteristic	Putting the pump in the temperature at negative 20℃ for 72 hours;then taking it out and putting it in a room temperature at 20± 5℃ for 2 hours,Under this circumstance,running through performance test and finding out that the pump still performs well.
High-temperature characteristic	Putting the pump in the temperature at 60℃ for 72 hours; then taking it out and putting it in a room temperature at 20 ± 5 ℃ for 2 hours,Under this circumstance,running through perforamance and finding out that the pump still performs well.
High-temperature & High humidity	Putting the pump in the temperature at 60℃ and the humidity at 95% for 72 hours;then taking it out and putting it in a room temperature at 20 ± 5 ℃ for 2 hours.Under this circumstance,running through performance test and finding out that the pump still performs well.
Temperature & humidity cycle test	After doing the temperature and humidity cycle test,-20℃* 2Hr → +25℃* 1Hr→ +60℃ 85%RH* 2Hr →+25℃*1Hr,for twelve times,the pump shall still perform the same functions proved by running through performance test.
Life test	The pump for drawing water, on 60 seconds, stopping for 30 seconds is as one cycle, Doing it for 500 hours, then examine the pump if it is in a good function.