1KG 20cm Lab Soil Sampling Instruments For Soil Collecting

Lab Soil Sampler

Product Introduction

YKT-C04 soil sampler adopts stainless steel sampling tube with built-in PVC lining, and external engineering plastic cutting head to ensure that the sampled product does not contact with metal. The closed circular cutting head adopts a unique double convex design, which reduces sampling resistance and soil Compression rate, threaded connection between the sampling tube and the cutting head to avoid the cutting head from falling off. The YKT-C04 soil sampler is equipped with a stainless steel cutting head for collecting round soil. The YKT-C04 sampling diameter is 5CM and the sampling length is 20CM. , A single point sampling volume is about 1KG.

Operation

1. Install the cutting head, PVC Liner, Sampling tube and Sample Tube Holder.
2. Connect the hitting handle, extend rod, drill, screw thread connection.
3. Select the sampling area.
4. Put the drill on the sampling area, and one person hold the hitting handle with two hands, the other person hit the handle with a hammer, then drill into the soil.
5. After reaching the sampling depth, pull the drill body up, then the soil is retained in the drill, After that, discharge the sampling tube holder, and pull the lining out, the soil sample with the lining out, thus completed a sampling.
6. Repeat the above procedures and continue sampling.

Product Display

Standard Configurations

1. ​Stainless steel sampler: 1pc
2. Engineer plastic cutting head: 2pcs
3. Sample Tube Holder: 1pc
4. Hammer: 1pc 
5. Wrench: 2pcs
6. Glove Box: 1pc
7. PVC liner: 20pcs
8. Stainless Steel cutting head: 2pcs
9. 1M Extension Rod: 5pcs
10. Bamboo knife, Bamboo Scraper: 1 each
11. 3m steel tape: 1M
12. Canvas Pack 1
13. Optional Aluminum Case