marine work ASTM 580 Standard cross wire spaced 16" Construction Wire Mesh

Construction Wire Mesh Introduction: 

Masonry ladder&truss type reinforcement mesh Raw material:low carbon steel wire,stainless steel wire

The mesh can be electro galvanized or hot dip galvanized after welding,it mainly have two type,ladder type and truss type.

The wire diameter is from2.5mm to 6mm.

Brick Wall Reinforced Mesh, Used in Building Surface, Wall, Ground and Bridge.

Customized specifications and sizes are accepted.

MATERIAL : Iron wire & stainless steel wire 304/316
Qijie metal joint reinforcement products conform to:
ASTM A951 (Standard Specification for Steel Wire for Masonry
Joint Reinforcement)
Our products pass the testing of ASTM A951,We tested in USA .
Tensile Strength - 80,000 p.s.i. | Yield Point - 70,000 p.s.i. minimum
Zinc Coating:
Mill Galvanized coating: (0.1 oz/ft²)
Hot-Dip Galvanized after fabrication: (1.5 oz/ft²)
Wire Diameter:
9 gauge or 3/16ӯ
Side Rods and Cross Rods available in any combination of the above.
Cross Rods welded 16” O.C.
Block Size: Standard Sizes: 4” wall - 16“ wall.
Other widths available on special request.

Masonry Block Wire Ladder has the continuous lengths of joint reinforcement that are embedded into the horizontal mortar joints of masonry walls. Joint reinforcement has long proven to be necessary for superior performance of masonry wall construction.

Variety: Truss-Mesh Reinforcement
Ladder-Mesh Reinforcement

Available at: hot dipped galvanized, electro galvanized or stainless steel

The specification :
The widht : 50mm,100mm,150mm,200mm,250mm etc.

Construction Wire Mesh Standard Specification:

* 4” wall - 16” wall
* Other widths available on special request
* (S) Standard: 9 ga. side rods x 9 ga. cross rods
* (EH) Extra Heavy: 3/16” side rods x 9 ga. cross rods
* (SHD) Super Heavy Duty: 3/16” side rods x 3/16” cross rods

*Tensile Strength - 80,000 psi
*Yield Point - 70,000 psi