car chassis straightening bench AA-ACR399E

Hydraulic vertical lifting bench, On the platform of 10mm thick plate, plate is 8mm thick, single panel width is 600mm wide, 5 holes, each hole below the ribs, and connected with the upper and lower plate, and lateral reinforcement is 8mm thick, the middle is 6mm thick, longitudinal ribs and transverse ribs and cross distribution. The rings are made of 10mm thick walled steel tubes, Two 360°rotating pulling towers; All accessories and clamping tools are forged with the mould, hardened and tempered under HRC28 degrees, and clamp tooth are heated under HRC40 degrees.