100NM3/Min Regenerative Air Dryer Micro Heat , 6 Bar Heatless Adsorption Dryer

100NM3/Min Capacity Micro-Heat Regenerative Adsorption Air Dryer Suppliers

The micro-heat regenerative adsorption air dryer (micro-heat dryer) is R & D products by used to absorb two kinds of advantages, such as micro-heat regeneration and heatless regeneration. The ability to adsorb water by a desiccant, and the compressed air is dried by the principle of variable temperature and pressure swing adsorption. The regenerated gas can be used to regenerate desiccant after raising the temperature, which not only improves the regeneration effect, but also reduces the consumption of regenerated gas.

Technical characteristics

+ PLC intelligent control is stable and reliable

+ Flange filling port is easy to replace

+ The unique view mirror design is more transparent

+ Advanced valve to ensure continuous use of more than 1 million times

+ Special air diffusion device ensures the service life of desiccant.

Main specialties

Energy-saving dew point sensor with standard configuration (medium and large series)

All function indicators are displayed.

Small size, light weight, convenient maintenance.

Heatless Adsorption Dryer Workflow

	1.Two towers drying in parallel Before start-up, the inlet and outlet valves of the left and right towers are always open, and compressed air passes through both towers to the point of use at the same time.
	2. The left tower is dried and the right tower is regenerated After the power is turned on, the right tower inlet / outlet valve is closed, the right tower regeneration inlet / exhaust valve is opened, and the compressed air flows through the left tower to be dried. The dry air passes through the orifice plate, and the right tower is regenerated after being throttled and expanded.At this time, the pressure of the right tower should be 0 kg. The compressed air containing moisture is released into the atmosphere through the right tower regeneration exhaust valve and muffler. left and right towers are always open, and compressed air passes through the two towers to the point of use simultaneously.
	3.Regeneration is over, ready to boost After 4 and a half minutes of regeneration, the right tower regeneration exhaust valve was closed, and the right tower began to boost pressure.
	4. The left tower is dry and the right tower is boosted The booster valve opens, and the pressure of the two towers slowly rises to equilibrium.After 5 minutes, the tower is changed to enter the next cycle.