FPV Video Receiver 1.7G VRX Support FPV Goggles for FPV VTX Analog Receiver Module

I.Main Features

lChannels 8CH;

lSupport FatShark,Skyzone and other glasses VR headset display straight plug and analog

display and other connection use;

lHigh-sensitivity reception-97 dBm;

lEfficient DC/DC power input: 7-36V;

lSupport 5V voltage output;

lShort click switch channel;

II.Product Parameter

lReceiver (ground end):

lInput voltage:7-36V DC(2-6S)

lOutput voltage:5V/0.5A

lVideo system:PAL/NTSC

lNumber of channels:8 channels

lChannel selection:Short click switch frequency

lReceiving frequency: 1680-1960MHz

lSensitivity:-97 dBm(MAX)

lAntenna interface:SMA(outer screw inner hole)

lModulation type:FM

2.Use a key to adjust the channel,short click switch channel,as shown in the figure below.

IV.Matters need attention:

lPlease install the antenna and then connect the power supply to avoid equipment failure;

lSelect the appropriate working frequency and set the transmitter to the same frequency as the receiving end(see the frequency table for details);

lThe input voltage is 7-36V(2-6S),do not use over the voltage range;

lThe output voltage current is 5V/0.5A.Please note that if the power is supplied to other equipment through the receiver output,the working current is limited to 0.5A.Do not use the voltage output end of the product over the 5V0.5A,otherwise the receiver may be damaged;

lBoth 5V and 5V-OUT are output terminals,do not connect to the power input terminal or the battery,otherwise it will cause damage.