High-temperature Insulation Wear-resistant And Corrosion-resistant Honeycomb Ceramic Regenerative Type

Product Description:

RTO heat exchange honeycomb ceramics Honeycomb ceramics are a kind of porous industrial ceramics. The specific surface area is large, the resistance is small, the fluid distribution is uniform, and the separation efficiency is high. Widely used in chemical industry, metallurgy, gas, food, environmental protection and other industries. The materials are mainly divided into cordierite, mullite, and alumina ceramics.
Regenerative high-temperature air combustion is a new energy-saving and environmentally friendly combustion technology. Honeycomb ceramic regenerator is the key component of regenerative burner, widely used in steel, machinery, building materials, chemical industry, petrochemical, paint and other fields. In various industries such as non-ferrous metal smelting, such as heating furnaces, hot blast furnaces, heat treatment furnaces, cracking furnaces, roasting furnaces, melting furnaces, soaking furnaces, oil and gas boilers, etc. This technology makes the two heat accumulators alternately absorb heat and release heat through the reversing device, recover the heat of the flue gas to the maximum extent, and heat the combustion-supporting air and gas in the furnace to above 1000°C, and even low-calorific value inferior fuels can achieve stable ignition and High-efficiency combustion, 25%-30% fuel saving, more than 15% increase in production, more than 40% slab oxidation loss, NOx emissions less than 100ppm, exhaust gas temperature below 150°C, greatly reducing the global greenhouse effect atmosphere. If most industrial furnaces in the country adopt HTAC technology, its economic and social benefits will be immeasurable, which will greatly alleviate the problem of energy shortage and greatly improve the living environment of human beings.

Features:

1. Use liquefied petroleum gas, clean and environmentally friendly.

2. High thermal efficiency, economical and practical, gas consumption cost is 50% lower than electricity consumption.

3. Easy and simple installation. Compared with a hair dryer, the cost is reduced by more than half.

Specification:

About us:

1. Good at new product development, over the past two years to develop two more popular models, each sales more than 2 million;

2. The factory has an area of 2000 square meters,from product design, Mold Design, circuit board development, production and manufacturing companies have completed their own, there are 8 production lines, high cost-effective products;

3. Manufacturer of core accessories for batteries and graphene heating pads;