conveyor belt splice component for rubber belt 1800 mm width

Steps to select your vulcanizing

The proper model selection for a Sectional vulcanizer depends on determining dimensions C and D (see diagram).

C - The platen length (C) is calculated by adding to the belt manufacturer’s recommended splice length.

•   8 inches (200mm) for fabric belt
•   12 inches (3000mm) for steel cord belt

D - The platen width (D) is determined by adding to the belt width.

•   6 inches (150mm) for fabric belt
•   8 inches (200mm) for steel cord belt

F - Width of the platen along the belt on bias. To figure this multiply by:

•   1.07 for 22 degree bias angle
•   1.05 for 17 degree bias angle

Dimensions C and D represent the outside platen dimensions. Custom sizes, rectangular configurations and multiple platen arrangements are also available upon request.