UV Panel Protection Aluminium Trim Board Wall Internal Corner Decoration

 

Application

Mill finish surfaces should be degreased with white spirit,followed by cleaning with mild detergent and rinsing with clean cold water. Wipe over with a dry soft cloth.

Feature

• Stock lengths are 4 metres long.

• Dimensions on drawings are shown in mm.

General: BS & European Standards and Specifications

Aluminium & Aluminium Alloy Extrusions: BS EN 755/515/573

BS EN 755: Extruded bar, rod, tube and profiles. Conditions for delivery, properties, and tolerances.

BS EN 515: Wrought products, temper designations.

BS EN 573: Chemical composition, form of wrought products

Anodising: BS EN ISO 7599

Anodising of aluminium and its alloys. General specifications for anodic oxidation coatings on aluminium.

Use
 

Polyester powder coated finish External applications Fusion bonded polyester powder coated surfaces will enjoy many years of good service if regularly maintained. For external applications, suggested cleaning intervals will vary between once every three months in harsh industrial or marine environments and up to once yearly in rural atmospheres. After removing any grease or oil deposits with a white spirit solution, use a mild diluted detergent to wash over and rinse with cold clean water. Dry off with a soft cloth. Abrasive cleaning agents or materials should not be used as surface scratching may occur. Internal applications After initial cleaning a regular wipe over with a soft cloth, to remove finger and dirt deposits, is all that is normally required to maintain good surface appearance.

Specification