STIM300 Analog MEMS IMU Sensor , 3 Gyro Inertial Measurement Sensor
STIM300 Analog MEMS IMU Sensor Low Price Inertial Measurement Sensor 3 Accelerometer, 3 Gyro, Pitch Rolll Heading Temp
Gyroscope specifications
| Parameter | Unit | IMU6-1 | IMU6-1A |
| Measuring range (customizable) | °/s | ±400 | ±400 |
|
Zero bias stability (@ Allan Variance) |
°/h | 1 | 0.5 |
|
Zero bias stability (1s smooth, 1σ, room temperature) |
°/h | 10 | 5 |
|
Zero bias stability (10s smooth, 1σ, room temperature) |
°/h | 5 | 1 |
| Zero-bias error over full temperature range | °/h | 20 | 10 |
| Random walk | °/√h | 0.2 | 0.1 |
| Zero-bias repeatability | °/h | 10 | 5 |
| Zero bias acceleration sensitivity | °/h/g | 1 | 1 |
| Resolution | °/h | 2 | 1 |
| Scale factor nonlinearity | ppm | 500 | |
| Scale factor repeatability | ppm | 500 | |
| Cross coupling | % | 0.1 | |
| Bandwidth | Hz | 125 | |
Add table technical indicators
| Parameter | Unit | IMU6-1y-1 | IMU6-1y-2 |
| Measuring range (customizable) | g | ±10 | ±30 |
| Zero-bias stability (Allan Variance @ 25 ℃) | mg | 0.02 | 0.05 |
| Zero-bias stability (1s smoothing) | mg | 0.1 | 0.5 |
| Zero-bias stability (10 s smoothing) | mg | 0.05 | 0.2 |
| Zero-bias error over full temperature range | mg | 1 | 3 |
| Random walk | m/s/√h | 0.001 | 0.002 |
| Zero-bias repeatability | mg | 0.1 | 0.5 |
| Scale factor repeatability | ppm | 500 | |
| Scale factor nonlinearity | ppm | 500 | |
| Bandwidth | Hz | 125 | |
"IMU6-1y-x" in the drawing is the product code ". According to the product naming rules of the company," y "in IMU6-1y-x can be" A "," B "," C "or no letter to distinguish different performance index requirements, and" X "can be" 1 "," 2 "." 3 "and" 4 "to distinguish different product plus meter ranges. "XX-XXX" is the product number.
IMU6-1y-x IMU is installed through 3 Φ4.4 through holes, and installed with 3 M4 screws (with spring washer and flat washer). When installing the connector, the plug shall be locked with the socket and the cable shall be fixed. In the figureA,BIs the installation datum plane of the inertia group.
It is recommended that the flatness of the mounting surface opposite to the reference surface shall not be greater than 0.01 mm, the verticality shall not be greater than 0.02 mm, and the surface roughness shall not exceed 0.8 μm.
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.