2959891 3387156 3809470 KIT HYD CYLINDER SEAL parts loder lift tift

One New Seal Kit Various Appliions & Models 3387038 3387038-A 3387156 3387156-A
Stevens Lake Parts One New Seal Kit || This Is An Aftermarket Part Made To Replace Its OEM Counterpart. || Interchangeable With 3387038 3387038-A 3387156 3387156-A || Some Listings Use Stock Images For Customer Reference - Your Part May Look Different

One New Cylinder Seal Kit Fits , Fits 416E Models Interchangeable with 2959891, 2959891-A
Stevens Lake Parts Rod: 2 1/4", Bore: 4 1/2" || This Is An Aftermarket Replacement Part Made To Meet Or Exceed OEM Specifiions. || Please Note That OEM Part Numbers, Models, & Dimensions Are Intended For Your Cross-Reference. Feel || Some Listings Use Stock Images For Customer Reference, Please Allow For Slight Differences.

Position the bottom tank securely. Install new 4P9942 and 4P9943 Seals on the bottom tank. An example of the new and former use of a capital "I" in a part number in a service publiion title follows: New ...6I0273Former ...6I0273
An example of the new and former use of a capital "I" in a part number in a service publiion picture caption follows: New ...6I0273Former ...6I0273
An example of the new and former use of a capital "I" in a part number in a parts manual page caption follows:
New caption.Lubrie the new seals with rubber lubricant or dish soap. Do NOT use petroleum products to lubrie the seals. Find the row of loing "dimples" on the grill side of the bottom tank. The first two modules will be installed at opposite ends of the bottom tank.2. Position the first module in the bottom tank so the modules center tab cutoff (wide side of the module) is directed away from the loing dimple in the bottom tank. Use care not to cut or distort the coolant seals during installation of the modules. (1) 3E5394 Receptacle. (2) 8T8734 Receptacle.
(3) 9W1951 Receptacle. (4) 8T8736 Receptacle. (5) 7X6195 Receptacle. (6) 7X6217 Receptacle.
(7) 8T8735 Plug. (8) 9W0847 Plug. The Deutsch pins and sockets require the 1U5804 Hand Crimp Tool. Often a seal problem does not become evident until the radiator is filled with coolant.3. Position the second module at the opposite end of the bottom tank. This modules center tab cutoff (wide side of the module) must also be directed away from the loing dimple in the bottom tank