High Pressure n2 Membrane Nitrogen Generator Manufacturers Oil Gas Field Industry

OSM high pressure Membrane nitrogen generator for Oil and Gas field

Membrane nitrogen generator Technology

Each application design has a unique chemical formulation and production process for the individual module fibers. At the heart of the technology are polymeric membrane materials that allow for rapid passage of a single gas, while minimizing the passage of others, when applying a pressure gradient across the membrane.

Membrane materials are formed into hollow fibers to provide maximum surface area for the high gas volume processing rate often required. Sumairui Gas holds over 100 patents on the design, packaging, and formulation of these hollow fiber membranes. The fibers are bundled into modules of various lengths and diameters to meet very specific flow rates and separation requirements. Typical modules have anywhere from a half a million, to over a million fibers in one bundle.

Two types of Module configurations are currently offered:

• Bore-Side Feed – The vast majority of membrane applications use a Bore-Side feed configuration. In this process, the incoming gas/air is directed down the center of the module fiber. The product gas exits the opposite end of the fiber, where it can be collected or diverted into a process application. The waste or unwanted gas passes through the wall of the fiber and exits the module through a side port, where it can be collected, diverted, or allowed to exhaust back into the atmosphere. This type of membrane module is utilized in applications where the feed pressure is less than 500 psig (34 bar).

• Shell-Side Feed – Shell-side feed modules operate by a similar principle as bore-side feed modules, except the incoming gas or air enters the module through a side port on the outer shell, allowing it to flow onto the outside of the fibers. The gas then preferentially permeates the fiber wall and flows down the center of fiber, where it exits the fiber bundle at the end of the module. The gas that does not permeate the wall of the fiber flows along the outside of the fibers, where it is exits through a collection plate at the opposite end of the module. This type of module is used for high pressure applications, 1200 psig (83 bar), and almost exclusively for hydrocarbon separations such as CO2 , CH4 , H2 , etc.

Design reference :

Compressed air inlet pressure 9 bar(g)/130 psi(g)
Air quality 1.4.1 according to ISO 8573-1:2010
Nitrogen outlet pressure 7 bar(g)/101psi(g)
Nitrogen quality 1.2.1 according to ISO 8573-1:2010.
Designed working temperature max 50 ℃
Dew point at Nitrogen outlet - 50 ℃

Notes:

Compressed air inlet pressure decide membrane performance
Following request of membrane nitrogen generator will be customized :
Compressed air pressure ＞14 bar(g)/203 psi(g) max up to 24 bar(g)/350 psi(g)
Working pressure ＞24 bar(g)/350 psi(g)
Dew point ＜ - 50 ℃
Movable/containerized , plug and play
Diesel drive
Other special requirements as per site conditions