1. Products details :

Steel Wire Rope Cable Stop Cable Clamp Double Hole Steel (3.0 Line Hole)

Prepare the Wire Rope: Ensure that the end of the wire rope is cleanly cut and not frayed.

Thread the Rope: Insert the end of the wire rope through one of the holes in the clamp. If you intend to create a loop, make sure to leave sufficient excess rope to form the desired loop size.

Create the Loop: If you're creating a loop, bring the end of the wire rope around and insert it through the second hole in the clamp. This forms a loop with the wire rope passing through both holes.

Position the Clamp: Place the double hole clamp over the looped section of the wire rope. Ensure that the holes of the clamp are aligned with the wire rope inside.

Tighten the Nuts: Thread the nuts onto the threaded ends of the clamp's bolts. Using a wrench, tighten the nuts evenly on both sides of the clamp. This applies pressure to the wire rope, preventing it from slipping out of the clamp.

Inspect the Installation: Conduct a visual inspection to confirm that the wire rope is securely held in place and that the clamp is properly seated. Verify that the nuts are tightened according to the manufacturer's recommended torque specifications.

When working with these types of clamps, it's essential to select the correct size and style of clamp that matches the diameter of the wire rope you're using. Following the manufacturer's instructions for installation and usage is crucial to ensure both safety and effectiveness.

2. Surface Treatment:

Steel Galvanized

3. Main Products:

4. FAQ: