1. Products details :

Steel Wire Rope Cable Stop Cable Clamp Double Hole Steel (3.0 Line Hole)

​

Prepare the Wire Rope: Ensure that the end of the wire rope is properly cut and not frayed.

Thread the Rope: Insert the end of the wire rope through one of the holes in the wire rope clip. If you're creating a loop, make sure to leave enough excess rope to form the desired size of the loop.

Create the Loop: If you're forming a loop, bring the end of the wire rope around and insert it through the second hole in the clip. This will create a loop with the wire rope passing through both holes.

Arrange the Clip: Position the wire rope clip over the looped section of the wire rope, ensuring that the holes align with the wire rope inside.

Tighten the Nuts: Place the nuts onto the threaded ends of the wire rope clip's bolts. Use a wrench to tighten the nuts evenly on both sides of the clip. This will create pressure on the wire rope, preventing it from slipping out of the clip.

Inspect the Installation: After tightening the nuts, visually inspect the installation to ensure that the wire rope is securely held in place and that the clip is properly seated. Verify that the nuts are tightened to the manufacturer's recommended torque specification.

It's important to note that when using steel wire rope clips, it's recommended to use the correct size and type of clip that matches the diameter of the wire rope you're working with. Additionally, follow the manufacturer's instructions and guidelines for proper installation, as improper installation can lead to failure and potential safety hazards.

2. Surface Treatment:

Steel Galvanized

3. Main Products:

4. FAQ: