3mm Natural Rubber Acoustic Floor Underlayment With Golden Film

Introduction:

Rubber is a high performance material of underlayment and provides excellent durability It is Manufactured from natural rubber, equipped with an integral fleece and an ALU vapour retardant. Due to the high density of this material, it is especially suited for frequently-used rooms and elsewhere in the building. This underlay will also improve the feel and sound when walking on your floor.

This underlay is denser than the basic foam underlay and its acoustic properties are much higher. It is Manufactured from natural rubber, equipped with an integral fleece and an ALU vapour retardant. Due to the high density of this material, it is especially suited for frequently-used rooms and elsewhere in the building. This underlay will also improve the feel and sound when walking on your floor. This underlay is also suitable where low-temperature underfloor heating <45 Degrees Celsius.

Feature:

Pack covers 10m2
Suitable for rooms with heavy traffic
Medium insulation
High sound reduction
Moisture barrier
Rubber backing

How to Install

Step 1: Clean Your Subfloor
Clean your subfloor using your broom and dustpan so that it is free of any foreign objects.

Step 2: Roll Out Your Underlayment
Roll your underlayment next to the wall. Start in the corner to keep it as even as possible across the room.

Step 3: Cut the Section
Once you have your underlayment firmly in place, cut the section using your scissors or utility knife.

Step 4: Roll Out the Next Section
Roll out the next section with the tape side over the overlapping film on the previous section.

Step 5: Butt Underlayment
Butt your underlayment sections together so that the tape side is flush up against the other piece of underlayment and on top of the overlapping film.

Step 6: Cut Section
Cut the next section of underlayment.