Aluminum Sheet Metal Stamped Parts 0.01mm For Automobile

Customized Aluminum Stainless Steel Sheet Metal Stamped Parts For Automobile

Automobile stamping parts are stamping parts used in automobiles, which are very important to the operation of automobiles. When the stamping factory processes automobile stamping parts, it is necessary to analyze some characteristics of automobile stamping parts in order to better produce

1. Effectively set process holes

In order to solve the problems caused by materials, the production and manufacturing staff select appropriate parts to punch out process holes when stretching the blank, and can also punch process holes in volatile parts during stretching. The process holes produced by stamping production should be of suitable size, not too large or too small. If the process hole is too large, the metal stamping part is very easy to cause the hole turning; if the hole is small, the top of the process part cannot get enough, so that the material cannot enter the part, and then the periphery of the top process hole is reduced in diameter condition.

2. Effective setting process supplement

The process supplementation in automobile stamping parts provides the basis for the parts that meet the standards. During the production process, material supplementation is carried out under the premise of stamping parts. Development also has a close relationship. In the whole process of manufacturing automobile stamping parts, when the stretched parts have a large gap, because the blank cannot be supplemented by external materials during stretching, there is a huge loss of parts that fail to pass the test. In order to better reduce the occurrence of this situation in the field of the automobile industry, after carrying out relevant analytical scientific research, it is decided to vacate the material resources that need to be supplemented in the pre-formation of the blanks, and assist the blank blanks to be replenished immediately.

3. Improvement of mold manufacturing

Common Stamped Parts in the automotive industry, if the upper and lower sides of the parts need to be improved, in order to better ensure the convenience of the actual operation of the process, the actual operation of placing the parts can be easily carried out after the completion of production and manufacturing. Under normal circumstances, auto parts molds often use the structural edge blanking method of wedges on both sides.