3pin XLR Audio To Fiber Converter Extender MIC Level And Line Level
3pin XLR Audio To Fiber Converter Extender MIC Level And Line Level
MIC Level and Line Level Audio TO Fiber Extender
A mic-level or microphone-level signal describes the voltage generated by a microphone when it picks up sound, typically just a few thousandths of a volt. This voltage varies in response to changes in sound level and distance. Of the four main types of audio signals, the mic level is the weakest and requires a pre-amplifier to bring it up to line level. The microphone level is usually specified between -60 and -40 dBu. (dBu and dBV are decibel measurements relative to a voltage.)
Our Mic- level audio to fiber converter integrates a preamplifier to boost the mic level to the line level. Our Audio Fiber converter can be built to a 1-channel Mic level in and 1-channel line Level out, or 2-channel mic level in and 2-channel line level out, etc.
Specification:
Opitcal:
| Wavelength | 1310nm&1470nm~1610nm |
| Output Power | -10~ -5dBm |
| Optic fiber | 50/125u multimode,62.5/125u multimode,9/125u single mode |
| Rx sensitivity | -25dBm |
| Optical connector | FC,ST,SC,LC (optional) |
| Number of Optical connectors | 1 or 2 |
| Distance | 0~500M (MM) / 0~20KM (SM) |
Mic level & Line level Balance Audio
| Input Connector | XLR(female) |
| Output Connector | XLR(male) |
| Mic level Audio | |
| Number of Channels | Input |
| Input Impedance | 2k Ohm |
| Dynamic Range | 60dB |
| Line level Audio | |
| Number of Channels | Output |
| Input / Output Impedance | 10K Ohm |
| Input capacitance LINE inputs | 10 pF |
| Max input/output voltage | 1.228Vp-p (+4dBu) |
| Frequency Response | 20 Hz～24kHz @±3dB |
| Sample Rates From | 48kHz |
| SNR | > 80dB |
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.