AT91SAM9G25-CU ARM-based Embbedded MPU ATMEL 16 Kbytes Data Cache 400MHz BGA217

• Core
• ARM926EJ-S™ ARM® Thumb® Processor running at up to 400 MHz 1.0V +/- 10%
• 16 Kbytes Data Cache, 16 Kbytes Instruction Cache, Memory Management Unit

• One 64-Kbyte internal ROM embedding bootstrap routine:
• Boot on NAND Flash, SDCard, DataFlash® or serial DataFlash. Programmable order.
•  
• One 32-Kbyte internal SRAM, single-cycle access at system speed
•  
• High Bandwidth Multi-port DDR2 Controller
•  
• 32-bit External Bus Interface supporting 4-bank and 8-bank DDR2/LPDDR, SDR/LPSDR, Static Memories

• MLC/SLC 8-bit NAND Controller, with up to 24-bit Programmable Multibit
• Error Correcting Code (PMECC)
•  
• System running at up to 133 MHz
•  
• Power-on Reset Cells, Reset Controller, Shut Down Controller, Periodic
• Interval Timer, Watchdog Timer and Real Time Clock
•  
• Boot Mode Select Option, Remap Command
•  
• Internal Low Power 32 kHz RC and Fast 12 MHz RC Oscillators
•  
• Selectable 32768 Hz Low-power Oscillator and 12 MHz Oscillator
•  
• One PLL for the system and one PLL at 480 MHz optimized for USB High Speed
•  
• Twelve 32-bit-layer AHB Bus Matrix for large Bandwidth transfers
•  
• Dual Peripheral Bridge with dedicated programmable clock for best performance
•  
• Two dual port 8-channel DMA Controllers
•  
• Advanced Interrupt Controller and Debug Unit
•  
• Two Programmable External Clock Signals
•  
• Low Power Mode
•  
• Shut Down Controller with four 32-bit Battery Backup Registers
•  
• Clock Generator and Power Management Controller
•  
• Very Slow Clock Operating Mode, Software Programmable Power Optimization Capabilities
•  
• Peripherals
•  
• ITU-R BT. 601/656 Image Sensor Interface
•  
• USB Device High Speed, USB Host High Speed and USB Host Full Speed with dedicated On-Chip Transceiver
•  
• One 10/100 Mbps Ethernet MAC Controller
•  
• Two High Speed Memory Card Hosts
•  
• Two Master/Slave Serial Peripheral Interface
•  
• Two 3-channel 32-bit Timer/Counters
•  
• one Synchronous Serial Controller
•  
• One 4-channel 16-bit PWM Controller
•  
• Three Two-wire Interfaces
•  
• Four USARTs, two UARTs, one DBGU
•  
• One 12-channel 10-bit Analog-to-Digital Converter
•  
• Soft Modem
•  
• Write Protected Registers
•  
• I/O
•  
• Four 32-bit Parallel Input/Output Controllers
•  
• 105 Programmable I/O Lines Multiplexed with up to Three Peripheral I/Os
•  
• Input Change Interrupt Capability on Each I/O Line, optional Schmitt trigger input
•  
• Individually Programmable Open-drain, Pull-up and pull-down resistor, Synchronous Output
•  
• Packages
•  
• 217-ball BGA, pitch 0.8 mm
•  
• 247-ball TFBGA, pitch 0.5 mm
•  
• 247-ball VFBGA, pitch 0.5 mm