WRM0207C-100RFI 100 Ohms ±1% 0.4W, 2/5W Chip Resistor MELF 0207 Metal Film

WRM Series

AEC-Q200

High reliability

Predictable pulse handling capability

Tolerances down to 0.1%

TCR down to 5 ppm/°C
 

Construction A metal film is deposited onto a high dissipation ceramic former to which tin plated teminating caps are fitted.
The resistor is adjusted to value by a helical cut in the film and the body is protected by a lacquer coating. Marking Resistance values are colour coded with four bands, three indicating value and one indicating the multiplier. (Note this describes standard marking, but certain values may still be supplied with the addition of a tolerance band following the multiplier.).
 

Terminations Material Plated steel cap. Solderability The pure tin finish produces ageing free contacts on which low melting solders can be used. Dipped area shall be covered with a smooth and bright solder coating after 3 seconds immersion at 215°C. Solvent Resistance The body protection and marking are resistant to all normal industrial cleaning solvents suitable for printed circuit boards.