SN74LS138DR 3-Line To 8-Line Decorders Integrated Circuit Chip / Demultiplexers Ic Circuit Board
SN74LS138DR 3-LINE TO 8-LINE DECORDERS/DEMULTIPLEXERS ic circuit board
FEATURES
• High-Bandwidth Data Path (up to 500 MHz (1) )
•5-V Tolerant I/Os With Device Powered Up or Powered Down
•Low and Flat ON-State Resistance (r on)Characteristics Over Operating Range (r on = 4 Ω Typ)
• Rail-to-Rail Switching on Data I/O Ports 0- to 5-V Switching With 3.3-V VCC – 0- to 3.3-V Switching With 2.5-V V Operation CC
•Bidirectional Data Flow With Near-Zero Propagation Delay
•Low Input/Output Capacitance Minimizes Loading and Signal Distortion (Cio(OFF) = 3.5 pF Typ)
• Fast Switching Frequency (f OE = 20 MHz Max)
DESCRIPTION/ORDERING INFORMATION (CONTINUED)
The SN74CB3Q3257 is a high-bandwidth FET bus switch utilizing a charge pump to elevate the gate voltage of the pass transistor, providing a low and flat ON-state resistance (r on). The low and flat ON-state resistance allows for minimal propagation delay and supports rail-to-rail switching on the data input/output (I/O) ports. The device also features low data I/O capacitance to minimize capacitive loading and signal distortion on the data bus. Specifically designed to support high-bandwidth applications, the SN74CB3Q3257 provides an optimized interface solution ideally suited for broadband communications, networking, and data-intensive computing systems
The SN74CB3Q3257 is a 4-bit 1-of-2 high-speed FET multiplexer/demultiplexer with a single output-enable (OE) input. The select (S) input controls the data path of the multiplexer/demultiplexer. When OE is low, the multiplexer/demultiplexer is enabled and the A port is connected to the B port, allowing bidirectional data flow between ports. When OE is high, the multiplexer/demultiplexer is disabled and a high-impedance state exists between the A and B ports
This device is fully specified for partial-power-down applications using I off . The I off circuitry prevents damaging current backflow through the device when it is powered down. The device has isolation during power off.
To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
Absolute Maximum Ratings
over operating free-air temperature range (unless otherwise noted)
| UNIT | ||
| VCC Supply voltage range | 0.5 4.6 | V |
| VIN Control input voltage range(2)(3) | 0.5 7 | V |
| Switch I/O voltage range(2)(3)(4) | –0.5 7 | V |
| Control input clamp current VIN < 0 | –50 | mA |
| port clamp current VI/O < 0 | –50 | mA |
| ON-state switch current | ±64 | mA |
| Continuous current through VCC or GND | ±100 | mA |
| Storage temperature range | –65 150 | °C |
STOCK LIST
| 19-217/S2C-FM2P1VY/3T | 6000 | EVERLIGHT | NEW | SMD |
| 1B22AN | 6000 | AD | NEW | DIP |
| 1N4758A-TAP | 10000 | VISHAY | NEW | DO-41 |
| 1N4936GP-E3/73 | 6000 | VISHAY | NEW | DO-41 |
| 1N5062 | 5000 | PHI | NEW | SOD-57 |
| 1N5062-E3/73 | 8000 | VISHAY | NEW | DO-15 |
| 1N5359BRLG | 8000 | ON | NEW | CASE17 |
| 1N5401RLG | 8000 | ON | NEW | DO-201 |
| 1N5819HW-7-F | 9000 | DIODES | NEW | SOD-123 |
| 1N5821RLG | 7500 | ON | NEW | DO-201 |
| 1N914BTR | 10000 | FSC | NEW | DO-35 |
| 1SMA5923BT3G | 10000 | ON | NEW | DO-214 |
| 1SMB5930BT3G | 5000 | ON | NEW | SMB |
| 1SMB5956BT3G | 5000 | ON | NEW | SMB |
| 2016L030DR | 7500 | LITTELFUS | NEW | SMD |
| 20279-001E-01 | 7500 | I-PEX | NEW | SMD |
| 20CL36 | 5000 | FAIRCHILD | NEW | TO-263 |
| 23LC1024-I/SN | 5000 | MICROCHIP | NEW | SOP8 |
| 2450AT18B100E | 5000 | JOHANSON | NEW | SMD |
| 2450BM15A0002E | 5000 | JOHANSON | NEW | SMD |
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.