XCMD500 * 1000 Double Roller Crusher 50-120 TPH Small Crushing Line

Device Information

Model: XCMD500 * 1000 (R)

Diameter of roller: 500 mm

Length of roller: 1000 mm

Feed size: less than 100 mm

Discharge size: less than 30-60 mm

Output: 50-120 TPH

Power: 37 kw * 2

Weight: 9.5 T

Transfer method: soft connection

Maintenance And Attention

In order to ensure the maximum output of the Double Roller Crusher, the feeding of the jaw crushers must be continuously and evenly distributed over the full length of the rolls. The discharge opening should be checked regularly for blockage and the feeding should be stopped before the motor stops working, and the motor should be stopped only when the material blocks fall completely and the rolls become idle. If the material is not evenly fed along the length of the roller, the roller surface not only wears faster, but also wears unevenly at all points, and there will be ring-shaped grooves in the operation of ball mill in mineral processing plant, so that the normal crushing work is damaged and the particle size of crushed products is not even. Therefore, in addition to the Double Roller Crusher used for coarse crushing, medium and fine crushing Double Roller Crushers are usually equipped with feeder to ensure continuous and uniform feeding, and the length of the feeder is equal to the length of the roll, so that the feeding material is uniform along the length of the roll.

Reasonable maintenance and correct operation and use of Double Roller Crusher can ensure long-term continuous work and reduce the stopping time. Only normal management and daily inspection of the normal working condition of Double Roller Crusher can prevent malfunction and ensure its continuous work.

Technical Reference Data

Equipment Output Diagram

Our Introduction