DS200CDBAG1BBB GE Contactor Driver Board Mark V Ge Turbine Control

Product Details:

The GE Contactor Driver Board DS200CDBAG1BBB opens and closes a contactor. All power, input signals, and output signals are connected to

the board through 1 connector on the board (1TB). The 1TB connector is made up of four sections. Three plug connectors supply the power and

signals to the connector. The four sections are 1TBA, 1TBB, 1TBC, and 1TBD. To remove the connector, use a screwdriver to help pry the

connectors apart from the board. Before you remove any cables, it is best practice to label all cables to avoid confusion when you install the

replacement board.

Also, one fuse connector is located on the board. If replacement is necessary use a 4 amp 125V, 2 AG slow-blow fuse. If the fuse blows often,

you might suspect that the board needs to be replaced.