Panoramic Borehole Inspection Camera 850TVL Deep Water Well Inspection Camera 2000m

Price Negotiable

Price: Negotiated

MOQ: 1 set

Delivery Time: 5-8 working days

Brand: Gold

Product Description

Panoramic Borehole Inspection Camera Deep Water Well Inspection Camera

Product Introduction

GYGD-IIIS Deep Water Well Inspection Camera is a method to monitor the change of the situation in the well on the TV screen on the ground by scanning the well hole with the TV camera.The panoramic camera can clearly observe the condition of the well wall, and can accurately find the damaged part and its cause, so that timely measures can be taken.

Application

The deep water wll inspcetion camera can be used to observe various characteristics and subtle phenomena of geological body in borehole, well, well, oil well, pile foundation, such as formation lithology, rock structure, geological structure, rock strike, fault, fissure, interlayer, karst fracture, etc. The conditions and faults in the well can be seen clearly, whether they occur on the wall or at the bottom of the well.

Technical Specification

Hole type	Vertical,Slant Hole
Depth	0-2000m
Camera Rsolution	850TVL
Pressure	Max.15Mpa
Probe Diameter	Φ40-Φ120mm
Cable Tensile Strength	250KG
Power	AC220V50Hz(DC12/24V Optional)
LED Display	8 Inch 4:3,1024*768Pixel
Storage	SD Card/U Disk,Standard 16G SD Card,32G Optional
Sensor	Sony 1/3 Inch CCD,0.1Lux

Operation Methord

1. Before use the machine, please check it first. And make sure good connection, cable is not damage, no leaks, winch work with flexible rotation

2. Install the pulley in central of well,winches and pulleys must be installed in the vertical plane.

3. Connect the parts well as photo shown

4. Plug power wire, and check the voltage. If the voltage is not same with the local, please stop the operation and check the circuit. If the power is less than 180v, the photo may be not clear, and winch may not work.

5. After good connection of every parts, turn on the voltage switch. LCD screen display, and probe light is start work.

6. Screen show the time, depth. And user can reset the depth.

7. Start winch, adjust the speed. Put the probe into well. When depth is 2-3 meter, change the direction, and take the probe out of well. Do it same 2-3 times, and make sure the system can work very well.

Product images