Overview

   The GDP-3D kit consists of two main parts, the survey tool itself and a portable controller that is used to operate and present the borehole survey data. There is a lithium battery inside the probe for the survey tool to get power. To connect to the portable controller, turn on the survey tool and the controller itself, then the software program should automatically detect that it is connected to the KXP-2X and you are ready to start your survey.

   The GDP-3D probe is consisted of two parts: the upper half and the lower half. The upper half electronic unit consists of three magnetometers, two accelerometers. They measure the magnetic field and gravity where the tool is placed along. The lower half is to increase the probe’s weight and length. The adapter with an ID number “010xxx” is used to connect a steel wire and slowly lower it down the hole. There are a switch (with a signal light), a charging interface and a antenna inside the adapter. The probe is powered by a 7.4V rechargeable lithium battery, which can be charged no less than 500 times. The endurance of the probe is about 20 hours.

   The portable controller is used to operate the survey tool. It is powered by 4 AAA size batteries. To turn on the controller, press the “Power” button for at least one second. (Do not release the “Power” button until the Company LOGO appears) Be caution that the controller is not resisted to water.

Specifcations:

Key Features

lThree magnetometers and three accelerometers for precise measurement of magnetic field and gravity.

lInternal memory for storing sensor data obtained during surveys.

lBluetooth connectivity with an Android controller for convenient data download and parameter settings.

lPowered by a 7.4V rechargeable lithium battery.

lLong endurance of approximately 20 hours.

lAdaptable to extreme environments with a wide working temperature range of -20℃ to 85℃.

Packing & Shipping

Contact us