Ultra-Low Power @ 3.6 V

- 110 µA/MHz, Low-Power Active, DC-DC enabled
- 110 nA sleep current with data retention; POR monitor enabled
- 400 nA sleep current with smaRTClock (internal LFO)
- 700 nA sleep current with smaRTClock (external XTAL)
- 2 µs wake-up from any sleep mode

 

 

12-Bit; 16 ch. Analog to Digital Converter

- Up to 75 ksps, 12-bit mode or 300 ksps 10-bit mode
- External pin or internal VREF (no external capacitor required)
- On-chip PGA allows measuring voltages up to twice the reference voltage
- Autonomous burst mode with 16-bit automatic averaging accumulator
#NAME?

 

 

Two Low Current Comparators

- Programmable hysteresis and response time
#NAME?

 

 

Internal 6-Bit Current Reference

- Up to ±500 µA; source and sink capability
#NAME?

 

 

Integrated LCD Controller

- Supports up to 128 segments (32x4)
#NAME?

 

 

Metering-Specific Peripherals

- DC-DC buck converter allows dynamic voltage scaling for maximum efficiency (250 mW output)
- Sleep-mode pulse accumulator with programmable switch de-bounce and pull-up control interfaces directly to metering sensor
- Data Packet Processing Engine (DPPE) includes hardware AES, DMA, CRC, and encoding blocks for acceleration of wire less protocols
- Manchester and Three-out-of-Six encoder hardware for power efficient implementation of the wireless M-bus specification

High-Speed Enhanced 8051 µC Core
- Pipe-lined instruction architecture executes 70% of instructions in 1 or 2 system clocks

 

 

Memory

- Up to 128 kB Flash; In-system programmable; Full read/write/ erase functionality over the entire supply range
- Up to 8 kB data retention RAM

 

 

Digital Peripherals

- Up to 57 port I/O; All 5 V tolerant with programmable drive strength
- Hardware enhanced UART, 2 SPI and I2C serial ports available concurrently
- Four general-purpose 16-bit counter/timers
#NAME?

 

 

Clock Sources

- Precision internal oscillators: 24.5 MHz with ±2% accuracy supports UART operation; spread-spectrum mode for reduced EMI
- Low power internal oscillator: 20 MHz
- External oscillator: Crystal, RC, C, CMOS clock
- SmaRTClock oscillator: 32.768 kHz crystal or 16.4 kHz internal LFO with three independent alarms

 

 

On-Chip Debug

- On-chip debug circuitry facilitates full speed, non-intrusive in system debug (no emulator required)
#NAME?

 

 

Package Options

- 76-pin DQFN (6x6 mm), RoHS compliant
- 40-pin QFN (6x6 mm), RoHS compliant
- 80-pin QFP (12x12 mm), RoHS compliant

 

 

Development Kit: C8051F960DK

Supply Voltage: 1.8 to 3.8 V
Temperature Range: –40 to +85 °C