CE Certified Laboratory Rotary Tube Furnace 1200C For Particular Materials

Product Overview for Rotary Tube Furnace

PTR D80/400/12 is a CE certified OD80mm ROTARY tube furnace with complete vacuum sealing flanges and rotating device. Furnace tube was build with Quartz tube, tube inside build with stiring blades, which can make the heated particular material in a very good heated uniformity.  Rotating speed 0.1-5RPM freely adjustable, heating zone 400mm in length and controlled by a precision 30 segments of digital temperature controllers independently. The heating zone is heated by HRE Heating wires up to 1200°C. It is an excellent furnace to process powder materials, and also can be used for nano or film growth by CVD.
 

Main Features

• Tmax 1100 °C
• Rotating tube furnace
• Dual steel structure, split furnace chamber easy access to the furnace tube
• Multiple atmosphere processes in a single cycle are available
• Fiber-insulated chamber with all round heating wires ensure uniform temperature
• Intelligent temperature controller with programmable 30 segments
• Quartz tube with blades build inside for material stiring
• Long life type N thermocouple
• CE certified, standard

Safety Measures

• Built-in ammeter and dual voltmeters for easy monitoring and troubleshooting.
• Overheat protection shuts down the tube furnace if temperature is outside of acceptable range (refer to controller's manual) or when the thermocouple is broken or malfunctions
• Power failure protection resumes furnace operation right after the point of failure when power is reestablished
• Microprocessor based self-tuning PID control provides optimum thermal process with minimal overshoot

Technical Specifications

Application Notes

• Don't fill any explosive gasses such as Hydrogen or Methane into the furnace tube without necessary safety controls and supervision
• 1700C tube furnaces with alumina tube are designed for use under vacuum and low pressure; 0.2 bars / 3 psi / 0.02 MPa
• To minimize the cracking rate of the ceramic tubes, please change the position (mark four points on the tube) each batch
• Small cracks may appear on the surface of the refractory ceramics over extended use. This is a normal occurrence and the cracks may be repaired with alumina coating