General Plastic PET Polyethylene Terephth Resin for Low Water Absorption and Organic Solvent Resistance
PET Resin is cream or pale-yellow crystal, with smooth and shiny surface. Resistance to creep deformation, fatigue resistance, abrasion resistance and dimensional stability are perfect. Small wear and tear but high hardness, its toughness is the largest in thermoplastic. The electrical insulation of PET is perfect and little be affected by temperature, however, poor corona resistance. PET is non-toxic, weather resistance, and anti-chemical stability is very good. PET is low water absorption, resistance to weak acids and organic solvents. Intolerance of hot water immersion and alkali.
Application:
1. PET is mainly used for fibers, and a small amount is used for films and engineering plastics.
2. Another use of PET is blow molding products, which are used in various bottles, such as water bottles, carbonated beverage bottles, and oil bottles.
1. Good electrical insulation performance, less affected by temperature, but poor corona resistance.
2. Non-toxic, weather resistance, good stability against chemicals, low water absorption, resistant to weak acids and organic solvents, but not resistant to hot water soaking, not alkali resistant.
3. The glass transition temperature of PET resin is high, the crystallization speed is slow, the molding cycle is long, the molding cycle is long, the molding shrinkage rate is large, the dimensional stability is poor, the crystallized molding is brittle, and the heat resistance is low.
4. The heat distortion temperature and long-term use temperature are very high among thermoplastic general engineering plastics.
5. Because of the high heat resistance, the reinforced PET is immersed in a solder bath at 250°C for 10 seconds, and it hardly deforms and does not change color. It is especially suitable for the preparation of electronic and electrical parts for soldering.
| Number | Item | Unit | Typical Value | Test Method | |
| 1 | Appearance | - | No color stain | Visual inspection | |
| 2 | Intrinsic Viscosity | dl/g | 0.64±0.015 | GB/T17932-2013 | |
| 3 | Carboxyl Content | mol/t | 30±4 | ||
| 4 | color Value | L | - | ≥80 | |
| 5 | b | - | 4±2 | ||
| 6 | Irregular Granule | wt% | ≤0.4 | ||
| 7 | Weight/100pcs | g/100 | 3±0.5 | ||
| 8 | Water content | wt% | ≤0.4 | ||
| 9 | DEG content | wt% | 1±0.2 | ||
| 10 | Melting Temperature | ºC | 260±2 | ||
| 11 | Ash Content | % | ≤0.06 | ||
| 12 | Iron Content | mg/kg | ≤2 | ||
| 13 | Aggregate | pc/mg | ≤1 | ||
| 14 | Powders | mg/kg | ≤100 | ||
1.Packing:
1100kg/bag, or per your requirement.18mt-20mt /20'FCL
2.Storage:
The resin should be stored in a drafty, dry warehouse and away from fire and direct sunlight. It should not be piled up in the open air.
3.Transportation:
During transportation, the product should not be exposed to strong sunlight or rain and should not be transported together with sand, soil, scrap metal, coal or glass. Transportation together with toxic, corrosive and flammable substance is strictly prohibited.
During transportation, the product should not be exposed to strong sunlight or rain and should not be transported together with sand, soil, scrap metal, coal or glass. Transportation together with toxic, corrosive and flammable substance is strictly prohibited.
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.