LMP-D214 Replacement SONY Projector Lamp VPL-D200 VPL-DX220 VPL-DW240 DX270

LMP-D214 For SONY Projector Lamp VPL-D200 VPL-DX220 VPL-DW240 DX270

Product Parameter

 Product Information

The SONY LMP-D214 replacement lamps are compatiable with VPL-D200 VPL-DX220 VPL-DW240 projectors.The working hour time is:3000-5000 hours,After repalcing our new lamps,the projector performance can be the same of the new original one and improve the effect of projection,and make you feel comfortable while using.

 Comment

projector is an electronic device that is used to display visual content onto a screen or other flat surface. The specific features and specifications may vary depending on the brand, model, and intended use of the projector.

 Bulb warranty

Access the Lamp Compartment: Locate the lamp compartment on your projector. The exact location may vary depending on the projector model. Usually, it is accessible from the top or bottom of the projector or through a side panel. Remove any screws or latches that secure the compartment.

Remove the Old Lamp: Carefully detach the old lamp by following the instructions provided in the user manual. In some cases, the lamp may be held in place by screws or clips. Gently release the lamp and disconnect any cables or connectors attached to it.

Install the New Lamp: Take the new lamp and align it correctly with the lamp housing. Make sure it fits securely and matches the connections of the previous lamp. Reconnect any cables or connectors that were disconnected during the removal process.

Secure the Lamp Compartment: Once the new lamp is in place, secure the lamp compartment by reattaching any screws or latches that were removed earlier. Ensure that the compartment is sealed properly to prevent any dust or debris from entering.