Foam gasket die cutting machine adhesive label tape foam hydraulic press

Main Technical Parameters:

Product Picture:

I , unwinding part ---------------max width 450mm
1, First unwind : 3 inch air-shaft , AC Motor , frequency control
second unwind ,3 inch air-shaft , magnetic powder brake
2, unwinding effective width : 400mm , max diameter is 24 inch ( 609mm), bear weight at 136KG
3, touch dancer sensor for first guiding roller
4, Servo motor control the 2 pulling roller ,
pulling roller is rubber material and hardness must at 75--80 degree , opening height is adjustable at least 24mm
II , Main Machine ------------ Die cutting area 450*400mm
1, Four shaft hydraulic machine
2, max cutting force : 40 Ton
3, shock proof
4, with light for the die cutting part so that easy installing mould and watch the die cutting part
5, plane die cutting area 450mm length , 450mm width
6, Safety Light Curtains at four corner .
III, electronic PLC control
1, LCD touch screen , computer control base
2, with password for data protection
3, can save the datas that setted
4, low maintainance
5, all the parts are under CE safety standard , electronic parts have CE mark
6, all the cutting / unwinding length and number are can set in the touch screen
7, cutting depth precision control at 0.025mm
8, stroke is controlled in 50--101.6mm
IV ,die cutting mould installing
with clamp tool and locking tool so that can put mould in directly and then locked , change mould in few time
V, mould plate package
1,with up and down cutting boards
2, stainless steel material mould plate , polished , easy control the cutting depth , can cutting both kiss cut and through cut
3, one piece PET or PVC sample for mould protective
4, Raiser ( tool to put conveyor belt ) for through die cutting . Conveyor belt part at main machine only.
VI, scrap/ waste Rewinding PAGE 3
1, three inch airshaft rewinding width AC motor control
2, max rewinding diameter is 609mm,
3, bearing weight at 22KGS
4, effective width 400mm
5, with dancer for the tension control
VII , knock down part for the holes
1, the punching area at least 400mmX400mm
2, Pneumatic control , and stroke at least 2 inch
3, Safety Light Curtains at four corner
4, not include the punching mould
VIII , Rewinder
1, with max roll diameter 609mm
2, Rewinding shaft is 3 inch airshaft
3, AC motor , speed can increase or descrease , with switch if forward/ reverse
4, effective width is 400mm ,
5, max bearing weight is 136KGS
6, Electromagnetic clutch tension control
NINE , CUTTER
1, effective width 400mm,
2, motor control the cutter operation
3 , can move forward / backword to suit for the unwinding length per time
TEN , slitter
1, 2 shaver type slitter installed on the knock down part table before sheeting and rewinding