2UUL TW41 CAMTWEEZ Flexible-Tip Camera Repair Tweezer with Anti-Scratch Contact and Non-Magnetic Body

A camera module is the one part on a phone board that punishes a careless tool: the glass is coated, the barrel is polished, and a steel tip leaves a mark you can never take back. The 2UUL TW41 CAM TWEEZ is built for exactly that moment. Its tip is soft where it touches and rigid where it holds — a grey soft-plastic bumper over a black hard-plastic core, two-shot molded as one piece — so you can grip a lens module, lift it, and set it down without scratching the glass, the coating, or the barrel. Non-magnetic body, 124 mm, 18 g. The tweezer you keep next to the camera jig.

• Flexible soft tip—— the contact point is soft plastic, so it grips a lens barrel or camera module without the metal-on-glass contact that scratches a coated lens or leaves tool marks on a polished housing.
• Anti-scratch contact—— every surface that touches the part is the soft bumper, not bare steel, so the tool is designed not to mark the part it holds.
• Anti-slip grip—— the bumper stays put against a smooth, oily or slightly rounded camera module, so you get a secure hold without clamping down hard enough to risk the glass.
• Two-shot molded tip—— a black hard-plastic support gives the tip its stiffness and spring-back, while a grey soft-plastic bumper wraps the contact area. Rigid where it needs to be, soft where it matters — molded as one piece, not glued on.
• Non-magnetic body—— a camera module sits next to magnets and is full of small steel parts; a non-magnetic tweezer won't grab a stray screw or snap the module out of your grip.
• 124 mm, 18 g, ergonomic handle —— long enough to reach into a phone chassis, light and slim enough to hold a steady pinch through a whole camera swap.