FTL Full Spectrum Aluminium UVB HID Lamp 70W 100W 150W HQI E27/E26 Bulb for Reptile Terrarium System

Metal Malide Lamp HQI 70W 100W 150W PAR38 Large beam angle Bead glass cover reptile UVB Lamp.

The beam angle is 60D

The lamp is same as EXO-TERRA,is made in the same OEM Factory,but not with the exo-terra brand.

It is 6000K,warm light,uvb at 30cm,it is 250-370uw/cm2,the lamp need HID ballast,then can be started.

35W metal halide uvb lamp is the equivalent of 1 mega-ray 100w mercury lamp.
70W metal halide uvb lamp is the equivalent of 1 mega-ray 160w mercury lamp.
150W metal halide uvb lamp is the equivalent of 2 mega-ray 160w mercury lamps.

Product Description :

1.New and innovative technology.
2.Extremely powerful UVB output.
3.High percentage of UVA.
4.UVB in the correct wavelength range.
5.Can be used as sole light soure.
6.The lamp on the market which is closest to the sun.
7.Optimal distance 30-50cm.
8.HID ballast is necessary for operation.

Product Feature:

Hight uvb output,long life,high uv maintenance rate,ultra low mercury content,green light
source,energy saving

Application:reptile breeding, indoor plant lighting

Quality assurance:according to the requirements of customers, if not qualified, 100% replacement.
Introduction to use.

Notice:

1.The lamps should be worked with Electronic ballast,fitting which is eligible and has correct mark.
2.It will take about 5 minutes from initially lighting to high luminance.
3.Working voltage:voltage change in short time is allowable as ±5% of the rated voltage marked by the fitting.The average working voltage should not exceed 3% of the rate voltage.
5.Please do not touch the lamp which was just taken off,do not install or take off the lamp until the lamp is cool,and please turn off the power firstly when it is going to be installed.

6.When it has the following phenomenons,life of the lamp is end.
-The color of the lamp change obviously;
-The brightness of lamp becomes very dark;
-The lamp starts and went out intermittently;
-The lamp can't start;

7.When install the new lamp,please clean the lamp with the soft cloth,to clean such as fingerprint and dust.
8.To avoid explosion,please do not harm the glass envelop or dripping water on it.Please use the fitting with cover,if the lamp is damaged,please replace it immediately.