My20-20-2 Tool Setting Instrument For Woodworking Engraving Machine
The Tool Setting Instrument My20-20-2 woodworking tool tester is mainly used for woodworking machinery tool measurement,wear,damage detection;Alarm signals will occur when the trip is exceeded,and damage accidents can be prevented. Applicable to China,Japan,Taiwan,Korea,Germany and other woodworking engraving machine and all kinds of woodworking control machinery,cutting machine,etc.
产品名称/Product name | 木工雕刻机对刀仪Moodworking engraving machine krifeinstument |
产品型号/Model | MY20-20-2 |
信号输出Sianal outou | NC常闭NCnomaly dosed |
对刀面直径/Diameter of autter face | φ20mm |
对刀面材质/Material of knife face | 钨钢超硬合金/Tungsten steel superhard allo |
表面处理/Surface prooessing method | 研磨4S镜面/Gnnd the4Smiror |
重复精度/Repeatab | 0.001mm(条件:操作速度50-200mm/min)/0.001mm(Condition operating speed50-200mm/min) |
触点寿命/Contactlife | 300万次/3million times |
接触力度/Efforts to contact | 1.3-24N(取决于感应方向/Depending on the sensing drection) |
预行程/Pretravel | 0 |
行程/Stroke | 8mm |
触点额定值/Contact rating | DC5-24V/20mA(MAX)推荐值/Recommended value 10mA电阻负荷/Resistive load |
电缆规格/Cable speafcation | 标配2m(直径R4.35mm.4芯屏蔽电缆,每芯φ0.7*02mm)/Sandand2M(dameterR435mm,4-00estieded cable each coeφ0702mm |
防水等级Materproof Rate | P65 |
净重Net weight | 363g |
毛重/Goss weich | 417g |
超程报警信号/Overange alam signal | 输出模式:NC/常闭(当信号断开后紧急停止/可订常开) |
/Output mode:NC/normaly cosed(emergency stopwhen the signal is disconnectedlcan be ordered nomlly open) | |
触点电压:DC24V20mA电阻负荷(特殊情况下须加负载,限电流) | |
/Contact voltage.DC24V20mAresistance load(load and curent limit should be addedin special cases) |
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.