OEM Industrial Pre-Mixed Refractory Ramming Mass for Aluminum Zinc Alloy Furnaces - 50-100mm Layer Application

High-performance dry ramming mix specifically formulated for aluminum and zinc alloy foundry furnaces. This pre-mixed refractory material requires no additional water or binders, ensuring consistent performance and extended furnace lining lifespan.

• Thoroughly clean furnace shell to remove debris and old refractory material
• Ensure surface is completely dry and free of moisture

• Use material as supplied - no water or binders required
• For large installations, use mechanical mixer for uniform consistency
• Apply in 50-100 mm thick layers for optimal compaction
• Compact each layer using pneumatic or manual ramming tools

• Allow natural curing for 24-48 hours
• Gradually heat furnace to remove residual moisture

• Regularly inspect lining for wear or damage
• Perform minor repairs as needed to extend service life

• Use appropriate compaction tools and equipment
• Follow manufacturer guidelines for layer thickness and curing times
• Ensure proper staff training on installation techniques