Braided Cable Pulling Sock for 12-150mm Cables with 10-30KN Rated Load and Hot Dip Galvanized Finish

Braided Cable Pulling Socks for 12-150mm Cables Rated 10-30KN

Product Overview

Most jacket damage on a power cable happens at the pulling point, unless the grip distributes the force evenly. The SWL sock answers that problem with a high tensile steel braid that closes around the cable over its full circumference, suiting diameters from 12mm to 150mm at working loads of 10-30KN. A reinforced collar takes the strain where the braid meets the pulling line, and the hot dip galvanized finish copes with coastal atmospheres. The sock is used for overhead terminations, substation hook-ups, underground duct pulls and emergency repairs.

Technical Specifications

Applications

· Terminating overhead line cables

· Connecting cables at substations

· Pulling cables through underground ducts

· Temporary fixing during outage repairs

Product Advantages

· Full Circumference Interwoven Grip — the steel braid closes evenly around the whole cable, so the jacket comes through the pull undamaged.

· 40 Percent Stronger, 30 Percent Faster — holding force beats conventional connectors by 40 percent while rigging time drops by 30 percent.

· High Tensile Steel with Reinforced Collar — the collar carries the pulling strain and keeps 12-150mm cables firmly connected.

· Hot Dip Galvanized Defence — the anti-corrosion layer is built for salt air, humidity and years of outdoor service.